I stopped everything in servers that I could possible stop and only had 5 or 6 services running that I could not shut down I then went into into task manager, services, open services. Launched into Windows 8 and then holding shift key and clicking restart computer and select troubleshooting option and on reboot select option 5 for 'safe mode with networking'Ĭomputer would not see the Main repeater in this mode directly connected so I had to use my Cisco E3000 router but I left all my static IP address set at 192.168.2.# even though the router is setup as 192.168.1.1 Installed Windows 8.1 Pro on a USB WD passport drive using Hasleo WintoUSB. Nothing showing in Services under task manager that mentions firewall.

Installed Windows 8.1 Pro, disabled Windows firewall, all three settings in advanced.

Windows 10 had Avast installed, disabled it as it takes over firewall duty from windows and then I disabled Windows firewall, all three settings in advanced. Tried all the programs and all find the repeater with no problems but all fail when trying to update the main repeater. anyone have any other ideas what to try next?Ĭonnected direct from computer network port to the main repeater and using static IP addressesĭownloaded and installed 7.0, 7.5, 7.6, 9.0, 11.5, and the latest 11.6 RA2 programs. Uninstalled virus protection, disabled windows firewall on Windows 10 and even tried a fresh install of Windows 8 and disabled firewall on it and still it will not pass through using a direct connection from PC to main repeater? At a lose. Been on chat and phone with tech support and I am being told it is a firewall issue.

Been trying to get the firmware updated for over a week now.

Wintousb 7.6